The sandblasting room machine equipment consists of several parts: sandblasting room body, sand shot recycling system software, automatic sandblasting machine, organic waste gas treatment system software, lighting fixture system software, and electrical equipment automatic control system. Removing the sand shot circulation and separating the system software, a part of the design scheme is the same. The key to this article is to compare the form of the sand shot circulation and recovery system software, and provide daily maintenance measures that must be carried out for the sandblasting room system software.
The sandblasting room recycling system software is a closed loop system software that recycles the sand shot sprayed by the sandblasting gun back to the sandblasting treatment cylinder. The dust shot in the sandblasting room is collected, and then raised to the dust shot separation equipment for dust shot separation. After separation, the effective shot shot is fully automatically burst into the shot storage box, and the sand shot in the shot storage box enters the sand cylinder automatically according to the command, Subsequently, a sandblasting gun is provided for another sandblasting treatment, which is the sand shot recycling system software.
Start the natural ventilation dust removal motor first, check the operation status, and restart the shot blasting cleaning machine after confirming that everything is normal. Before starting the shot blasting cleaning machine, do not open the control gate valve for supplying iron shot. To frequently check the cleaning quality of stainless steel plates, it is necessary to adjust the angle of view of the shot wheel and the roller transportation speed when necessary. Check the stainless steel plate for any directional deviation anytime and anywhere, and the deviation should be immediately removed. Pay attention to the vibration and sound box during the operation of the shot blasting machine to ensure everything is normal, as well as the temperature rise of the rolling bearings and motors. If any abnormalities are found, stop the machine for inspection, fault detection, or replace the blades. When the shot blasting and rust removal room is completed, the shot tube must be turned off first and the air supply must be terminated; Turn off the shot blasting motor and finally stop the exhaust fan. If an abnormal situation occurs, shut down the machine immediately, investigate the cause, and immediately clear it. Wet cold thick steel plates are prohibited from entering the shot blasting and rust removal room for shot blasting and rust removal.
There are two popular methods for sandblasting room recycling system software in the current sales market: pedal recycling and force recycling. Simply put, force recovery refers to the design of several small cone shaped buckets on the wooden floor of the sandblasting room. A hole is made at the bottom of the cone shaped bucket, which is caused by the ventilation duct to cause the outdoor cyclone dust collector. A high-pressure centrifugal fan is selected to extract the dust particles that fall from the cone shaped bucket at the bottom of the room. After being separated by the cyclone dust collector, the sand particles effectively fall into the storage box in the middle of the separation equipment, Then enter the sand tank to complete the cycle.